EZ Pressure Tester for paintball marker low pressure regulators with output up to 180psi. Low pressure 0-180psi gauge installed. Includes low pressure adapter AND low pressure hose.
Use it to set your output pressure and to check for performance to ensure that the regulator isn't creeping (which can be very bad for a paintball gun and damage seals/solenoids inside the gun).
Easy "EZ" operation. Simply screw the low pressure adapter into the bottom of the tester, connect the low pressure hose to the adapter barb and to the output barb from your guns low pressure regulator and then close the side lever on the EZ Pressure Tester. Gas up your gun. Pressure will read on the gauge immediately. Press the button to release the lever and degas the pressure gauge. Repeat to check for consistency or leave it pressurized and watch the gauge to make sure the pressure isn't slowly increasing (creep). De-gas gun and pressure tester completely before removing the hose.
Designed to use the minimum amount of air from your tank as possible so you don't waste air/gas while testing and setting up your equipment at home.
Full set for testing Autocockers, that includes the Low Pressure Adapter and a low pressure gauge can be found here.
Extra pressure gauges available also here.
Pressure gauge style may vary from shown.Push button EZ Pressure Tester with 0-180PSI Gauge installed
Low Pressure Adapter
Low Pressure Hose
Use it to set your output pressure and to check for performance to ensure that the regulator isn't creeping (which can be very bad for a paintball gun and damage seals/solenoids inside the gun).
Easy "EZ" operation. Simply screw the low pressure adapter into the bottom of the tester, connect the low pressure hose to the adapter barb and to the output barb from your guns low pressure regulator and then close the side lever on the EZ Pressure Tester. Gas up your gun. Pressure will read on the gauge immediately. Press the button to release the lever and degas the pressure gauge. Repeat to check for consistency or leave it pressurized and watch the gauge to make sure the pressure isn't slowly increasing (creep). De-gas gun and pressure tester completely before removing the hose.
Designed to use the minimum amount of air from your tank as possible so you don't waste air/gas while testing and setting up your equipment at home.
Full set for testing Autocockers, that includes the Low Pressure Adapter and a low pressure gauge can be found here.
Extra pressure gauges available also here.
Pressure gauge style may vary from shown.Push button EZ Pressure Tester with 0-180PSI Gauge installed
Low Pressure Adapter
Low Pressure Hose
