Adapter for EZ Pressure Tester to allow any low pressure hose to be connected for testing of low pressure regulators on many paintball guns including guns like Autocockers and Intimidators.
Use it to set your output pressure and to check for performance to ensure that the regulator isn't creeping (which can be very bad for a paintball gun and damage seals/solenoids inside the gun).
Simply screw the adapter into the bottom of your EZ Pressure Tester and then close the side lever. Press the button to release the lever and degas the pressure gauge. Repeat to check for consistency or leave it pressurized and watch the gauge to make sure the pressure isn't slowly increasing (creep).
Designed to use the minimum amount of air from your tank as possible so you don't waste air/gas while testing and setting up your equipment at home.
Low Pressure Gauge for your EZ Pressure Tester is available here.
Full kit for testing all Autococker pressures, including low pressure available here.
Use it to set your output pressure and to check for performance to ensure that the regulator isn't creeping (which can be very bad for a paintball gun and damage seals/solenoids inside the gun).
Simply screw the adapter into the bottom of your EZ Pressure Tester and then close the side lever. Press the button to release the lever and degas the pressure gauge. Repeat to check for consistency or leave it pressurized and watch the gauge to make sure the pressure isn't slowly increasing (creep).
Designed to use the minimum amount of air from your tank as possible so you don't waste air/gas while testing and setting up your equipment at home.
Low Pressure Gauge for your EZ Pressure Tester is available here.
Full kit for testing all Autococker pressures, including low pressure available here.