This is a safety tool, it helps with installing the safety into an inception grip frame.
The smaller alignment piece is inserted into the safety hole and the safety pushed through from the back of the frame and up against the alignment piece. The spring and ball bearing are dropped into place through the top chamfered hole.
Then you insert the pin of the logo'd larger piece through the side and above the ball detent. You slide this section down compressing the ball detent and spring into position then simply push the safety all the way over and everything will go into place.
The smaller alignment piece is inserted into the safety hole and the safety pushed through from the back of the frame and up against the alignment piece. The spring and ball bearing are dropped into place through the top chamfered hole.
Then you insert the pin of the logo'd larger piece through the side and above the ball detent. You slide this section down compressing the ball detent and spring into position then simply push the safety all the way over and everything will go into place.
